0

N+X Modular Compact UPS System
EP series

[N+X Hot Redundancy Design]

Rated capacity: 20KVA~90KVA


Scope of application

  • Computer Center
  • Computer room
  • Security monitoring host
  • Control Center
  • Highly stable power supply to protect equipment/environment
    		•

    Inquiry
    Back
    Prev
    Next
    Model UPS FT-EP12U UPS FT-EP15U
    Single power module output capacity (W) 20K or 30K
    The efficiency of the whole machine 94.5%, online double conversion design
    Enter Voltage 415/240V or 400/230V or 380/220V (three-phase four-wire), also can be specially designed according to requirements
    Voltage range 208V~478V @ <70% load; 305V~478V @ 100% load
    Frequency 50Hz or 60Hz (automatic detection)
    Frequency range 40Hz~70Hz
    Work factor improvement ≧0.99
    Harmonic Distortion (THDi) ≦3%
    output Rated voltage 415/240V or 400/230V or 380/220V (three-phase four-wire), also can be specially designed according to requirements
    Rated frequency 50Hz or 60Hz
    Stability rated voltage ± 1%; rated frequency ± 0.1Hz
    Waveform Pure sine wave
    Crest ratio 3: 1
    Power factor 1
    Harmonic distortion (THDv) ≦2% @linear load; ≦4% @non-linear load
    Conversion time Zero conversion
    Battery
    Type Lead-acid water-free and maintenance-free closed type
    Battery pack Working voltage is 240+240VDC
    Discharge time Configure the battery pack according to customer needs to meet the discharge time
    Charging method Microcomputer controlled intelligent charging to extend battery life
    Protect With battery overcharge and discharge, battery overheating and battery short circuit protection
    Operation tips
    LED lights With mains normal, bypass power supply, UPS operation, battery supply and UPS failure lights
    LCD panel With UPS status and operation instructions, including input/output: voltage/current/frequency/actual power/apparent power/power factor , Load: capacity/percentage, battery: voltage/current/capacity and UPS fault display records (up to 500 records)
    Alarm sounds Battery discharge: one beep every two seconds; battery low: one beep every half second; output overload: one beep every second ; UPS abnormal: long beep
    Display panel The 5.7-inch LCD display panel makes it easier and faster to operate the UPS.
    Panel monitoring The LCD panel can record abnormal voltage/frequency and load warning range according to user settings.
    Communication interface
    Standard configuration RS-232/ USB / smart card slot
    Optional The smart card slot can be installed: RS-232/USB/SNMP/AS-400/ModBus, etc.
    Machine function
    Modularization Using modular design to achieve rapid detection and convenient replacement
    shared battery pack The shared design of the battery pack can ensure the average battery charge
    Password maintenance management To avoid operation by non-maintenance and management personnel, the LCD panel can set a password by itself. When the system is modified or the UPS is turned on, the correct password must be logged in to operate
    N+X hot redundancy Hot redundant parallel connection function, with future expansion capability, when the system is operating normally, each single power module will automatically share the current output For the back-end load; when any power module fails, the rest of the normal modules will automatically connect to supply all loads, and the power protection capability of the equipment will be increased to the highest point
    Warning display With buzzer sound and panel display dual prompt
    Overload capacity 101%~110% supply for one hour; 111%~125% supply for ten minutes; 126%~150% supply for one minute; > 151% provide 200ms and then switch to bypass. After the overload condition disappears, the system will automatically switch back to the inverter power supply mode.
    Protection circuit With output short-circuit, UPS leakage, input lightning surge protection, over-temperature protection and overload protection
    ECO mode Provide ECO power saving mode, increase performance to 98%, and achieve the purpose of energy saving and power saving
    Other functions With non-disruptive manual maintenance bypass function. No need to interrupt the backend load
    Web/SNMP management interface The SNMP network management card can be installed to remotely manage the UPS
    Monitoring software Support Win 2000/XP/Vista/7/8/10, Win Server 2003/2008/2012/2016, Linux, Unix and Mac systems
    Safety certification With the Commodity Verification Registration Certificate (BSMI) of the Bureau of Standards, Metrology, Inspection and Quarantine of the Ministry of Economic Affairs, CNS14843-1 (93 edition) and CNS14757-2(99 Year edition)
    Noise (within one meter) ≦70dBA
    Use environment: temperature/humidity 0℃~40℃; 0%~95% (non-condensing)
    Dimensions, length x width x height (mm) 1000 x 515 x 1285 1000 x 515 x 1420

    *If there is any change to this product, a specification confirmation letter will be attached.
    *For more detailed information, please call to contact the specialist.